Pacific Research Solutions RI-200 User Manual
Page 4
Pacific Research Solutions
RI-200 User Manual
Page 3
4.5.54
Set Key-Code for User Commands
4.5.55
Password for S-Command Access
4.5.56
Password for Telephone Incoming Ring Access
4.5.57
Password for Telephone Incoming Control Access
4.5.58
Remote Software Reset
4.5.59
Remote EEPROM Initialize
4.5.60
User Telephone Off-hook Command Names
4.5.61
User Defined S-Commands, Rename a System Command
4.5.62
User Command Names
4.5.63
Macro Editor, Set Starting Line Number Pointer
4.5.64
Macro Editor, Insert S-Commands
4.5.65
Reserved
4.5.66
Reserved
4.5.67
Reserved
4.5.68
Macro Line Jump
4.5.69
Exit S-Command Programming
4.5.70
Telephone Outgoing Call Mode
4.5.71
Telephone Incoming Call Mode
4.5.72
Telephone CTCSS/DCS Tone Panel Enable
4.5.73
Telephone Incoming Call Control Timeout
4.5.74
Telephone Incoming Call Ring and Command Password Timeout
4.5.75
Telephone Incoming Ring Delay
4.5.76
Telephone TX Ring Limit
4.5.77
Telephone Off-hook Timeout Timer
4.5.78
Telephone Inactivity on Receiver Timeout Timer
4.5.79
Telephone Incoming AGC Audio Level
4.5.80
Flash Hook Switch
4.5.81
Telephone DTMF or Pulse Dialing Select
4.5.82
Telephone On/Off-hook and Access/Account Code
4.5.83
Edit Telephone Access and Account Code
4.5.84
Telephone Number Auto Dialer
4.5.85
Set an Auto Dial Number for Use
4.5.86
Telephone Number Accept Table Enable
4.5.87
Edit Telephone Number Accept Table
4.5.88
Telephone Number Reject Table Enable
4.5.89
Edit Telephone Number Reject Table
4.5.90
Wait for Dial Tone Timer
4.5.91
Reserved
4.5.92
Reserved
4.5.93
Reserved
4.5.94
Reserved
4.5.95
Reserved
4.5.96
Reserved
4.5.97
Reserved
4.5.98
Reserved
4.5.99
Reserved
5.
MACRO PROGRAMMING ..................................................................................... PAGE 56
5.0
Macro Programming Introduction
5.1
Programming Standard User Commands and Macros
5.1.1
Passing S-Commands to Another Controller
5.2
Telephone Commands
5.3
User S-Commands
5.4
Programming CW messages
5.5
Exiting Programming Mode