RGBLink VSP 628S User Manual - Manual (Page 124)

VSP 628S User Manual 124
C. Upgrading Software
Download the IP software
Turn off the power, take the two coding switch to ―ON‖ state as below:
Connect one side of the RJ11 download line to the RS232 on the video
processor, and the other side being connected to the serial port on the PC，
switch on the power and wait for 2 minutes.
Double click to run flash magic, setting as below:
Firstly, users can choose the right serial port, set the Baud rate to 9600,
choose LPC2368, and to load the aim document (hex file) for IP board
upgrading;
Secondly, tick the item below to confirm.
Finally, click the ―start‖ button.