Denon AVR-4306 - Manual (Page 67)

62
Advanced Operation Advanced Operation
• Press the MUTING button to mute the audio temporarily.
The muting level is same as set with “Volume Control”.
• Cancelling muting mode:
Press the MUTING button again, or press the VOLUME button on
the remote control unit.
ZONE2/3/REC SELECT
FUNCTION
Remote control unit operations during multi-
source playback
1 Select the zone which you want to operate
pressing the
AMP button.
2 Press the ZONE2 (ZONE3) ON button to turn on
the zone power.
Press the OFF button to turn off the zone power.
3 Select the input source you wish to output.
When the input source is set to TUNER, the preset channel
can be selected using the CHANNEL + and – buttons on the
remote control unit.
4 The volume of the outputs of the different zones
can be adjusted with the
VOLUME button on the
remote control unit.
The output level can be controlled only if the zone volume
level is set “variable” at “Volume Control” in the “System
Setup Menu” (
page 77).
DEFAULT VOLUME SETTING
ZONE2 : –40 dB
ZONE3 : –40 dB
The zone volume can be adjusted within the range of –70 to
18 dB, in steps of 1 dB.
AMP
ZONE2 ON/OFF
MUTING
CHANNEL VOLUME
ZONE3 ON/OFF
2 With “ZONE2 SOURCE” or “ZONE3
SOURCE” displayed, turn the FUNCTION knob
to select the source you want to output appears
on the display.
Outputting a program source to amplifier,
etc., in the ZONE2 (or ZONE3) room
(ZONE2 or ZONE3 SELECT mode)
• If and only if the digital signal being input from the digital input
terminal (optical/coaxial) is a PCM signal, it is output from the
ZONE2 and ZONE3 audio output terminals.
• When certain digital signals are being input, noise may be
output from the ZONE2 and ZONE3 audio output terminals.
• When “DENON LINK” is assigned at “Digital In Assign”, it is
not possible to output the PCM signal and Network Audio
signals (Internet radio, music server, USB) being input from the
digital audio input terminal from the ZONE2 and ZONE3 audio
output terminals (
page 67).
• The signals of the source selected in the ZONE2 mode are also
output from the VCR-1, VCR-2 and CDR/TAPE recording output
terminals.
• About the MULTI ZONE connections ( page 60, 61).
1 Press the ZONE2/3/REC SELECT button to
display the “ZONE2 SOURCE” or “ZONE3
SOURCE” on the display.
• If the “ZONE2 SOURCE” is selected, the MULTI
indicator lights.
The display switches as follows each time the button is
pressed.
3 Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
ZONE3 ZONE2
(RECOUT)