Denon AVR-4306 - Manual (Page 85)

80
Advanced Setup – Part 1 Advanced Setup – Part 1
Network Setup
If you are using a broadband router (DHCP function), there is no need to make the settings at “Network Setup”, since the DHCP
function is set to “ON” in the AVR-4306’s default settings.
If the AVR-4306 is being used connected to a network without the DHCP function, the network settings must be made. In this case,
some knowledge of networks is required.
Setting the IP Address
Set this when “OFF” is set for “DHCP”.
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
1 Press the CURSOR D D or H H button to select
“Network Setup” at the “System Setup Menu”,
then press the
ENTER button.
• The “Network Setup” screen appears.
2 Press the CURSOR D D or H H button to select “IP
Address”, then press the ENTER button.
• The “IP Address” screen appears.
3 Press the CURSOR F F or G G button to select
“OFF”.
• The DHCP function is disabled.
Setting the Proxy
Make this setting when connecting to the Internet via a proxy
server.
1 Press the CURSOR D D or H H button to select
“Proxy” at the “Network Setup” screen, then
press the
ENTER button.
• The “Proxy” screen appears.
2
Press the CURSOR F F or G G button to select “ON”.
• The proxy server is enabled.
4 Press the CURSOR D D or H H button to select the
desired setting item, then press the CURSOR G G
button and CURSOR D D or H H button to input the
address.
IP Address:
Set the IP address within the ranges shown below. The
Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask:
When connecting an xDSL modem or terminal adapter
directly to the AVR-4306, input the subnet mask indicated in
the documentation supplied by your provider. Normally input
255.255.255.0.
Gateway:
When connected to a gateway (router), input its IP address.
Primary DNS / Secondary DNS:
If there is only one DNS address indicated in the
documentation supplied by your provider, input it at “e. 1st”.
If there are two or more DNS addresses, input the first one at
“f. 2nd”.
5
Press the ENTER button to enter the setting.
• The “IP Address” menu reappears.
• DHCP (Dynamic Host Configuration Protocol):
These are systems by which the IP address and other network
settings are automatically set for the AVR-4306, computer,
broadband router and network devices.
• DNS (Domain Name System):
This is a system for converting the domain names used when
browsing Internet sites (for example, “www.jp”) into the IP
addresses actually used for communications (for example,
“202.221.192.106”).
3 Press the CURSOR D D or H H button to select the
desired setting item, then press the CURSOR G G
button and CURSOR D D or H H button to input the
character or number.
Proxy:
Input the proxy server domain name or address.
Port:
Input the proxy server port number.
4
Press the ENTER button to enter the setting.
• The “Network Setup” menu reappears.