Denon AVR-4306 - Manual (Page 91)

86
Advanced Setup – Part 2 Advanced Setup – Part 2
• If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main”
( page 83) is displayed at the top right of the screen.
• We recommend using with the crossover frequency set to
“80Hz”, but depending on the speaker, setting it to a different
frequency may improve frequency response near the crossover
frequency.
• The crossover frequency mode is valid only when subwoofer is
set to “ON”, and when one or more speakers are set to
“SMALL”, as described in section “Speaker Configuration”
settings (
page 82).
• If “LFE” is selected at “Subwoofer Setup”, the frequencies
can only be selected for speakers set to “Small” at “Speaker
Configuration”.
• If “LFE+Main” is set at “Subwoofer Setup”, the frequencies
can be selected regardless of the speaker size setting.
• For the “WIDE SCREEN” and “7CH STEREO” DSP simulation
modes, the surround speakers can be set separately.
Setting the crossover frequency individually
for the different channels
1 Press the CURSOR F F or G G button to select
“Advanced” at the “Crossover Frequency”
screen.
2 Press the CURSOR D D or H H button to select the
speaker to be set.
3
Press the CURSOR F F or G G button to select the
frequency.
Selecting the Surround Speakers for the
different surround modes
• This menu is displayed when both surround speakers A and B
are used.
• At this screen preset the surround speakers to be used in each
surround modes.
1 Press the CURSOR D D or H H button to select
“Surround Sp Setup” at the “Speaker Setup”
menu, then press the
ENTER button.
• The “Surround Sp Setup” screen appears.
2 Press the CURSOR D D or H H button to select the
surround mode, then press the CURSOR F F or G G
button to select the surround speaker.
A:
When surround speakers A is used.
B:
When surround speakers B is used.
A + B:
When both surround speakers A and B are used.
3
Press the ENTER button to enter the setting.
• The “Speaker Setup” menu reappears.
4
Press the ENTER button to enter the setting.
• The “Speaker Setup” menu reappears.
2 About Speaker type setting when using both
surround speakers A and B
• If “Small” is set for either surround speakers A or B, the output
is the same as when “Small” is set for both A and B.