Scotsman NME1854 - Manual (Page 21)

NME1854 & FME2404
January 2000
Page 21
In some areas the water supply to the ice machine
will have a great deal of minerals in it, and that will
result in an evaporator and auger becoming coated
with these minerals, requiring a more frequent
removal than twice per year. If in doubt about the
condition of the evaporator and auger, the auger
can be removed so the parts can be inspected.
Note: Water filters can filter out suspended solids,
but not dissolved solids. “Soft” water may not be
the complete answer. Check with a water
treatment specialist regarding water treatment.
For more information on removal of these
parts, see REMOVAL AND REPLACEMENT.
1. To remove the auger, remove the front and top
panels.
2. Push back bail clamp holding ice chute cover to
ice chute, and remove cover.
3. Unscrew and remove ice sweep.
4. Loosen band clamp under ice chute, and
remove ice chute from evaporator.
5. Remove 4 allen screws holding breaker to
evaporator.
6. Drain the evaporator by pulling down and
uncapping the evaporator drain tube.
7. Pull up to remove auger.
After the auger has been removed, allow the auger
to dry: if the auger is not bright and shiny, it must
be cleaned.
Clean the auger and evaporator as required. DO
NOT HONE THE EVAPORATOR.
8. Replace the water seal.
9. Reverse to reassemble.
AUGER MAINTENANCE
ALLEN
SCREWS
BREAKER &
BEARING &
AUGER
ASSEMBLY
Moving Parts Hazard.
Disconnect electrical
power before beginning.
CAUTION
The auger has
sharp edges,
handle with care.