Sierra Video 3232HD-3G - Manual (Page 43)

ASPEN 1616 AND 3232HD/SDI 3G ROUTING SWITCHER
33
Source based Switching
1. Select an input
2. Select (enable level) to be switched by toggling the “A” and “V” button.
3. Select an output (. In auto take mode, the switch will occur immediately)
4. If auto take mode is not enabled the “Take” button will blink RED- press take to initiate
the switch, or you can select additional outputs to preset takes for multiple outputs to the
same selected source. In the latter case all selected outputs will be switched to the
selected source when take is pressed.
Source based Status
When an input is selected, the output(s) currently connected to that input will light.
Selected input button will be GREEN.
Output button colors:
CYAN to indicate video and audio.
GREEN to indicate video only.
BLUE to indicate audio only.
Salvo
Salvos are programmed via the web page (see the Salvo Setup Section).
To fire a Salvo;
 Select the FUNC button. The button turns YELLOW
 Select the SALVO button. This button will illuminate BLUE.
 Buttons One (1) to Sixteen (16) in the INPUT section illuminate BLUE to indicate
the programmed salvos.
 Select any of the illuminated input buttons. The selected button will blink CYAN.
 The TAKE button begins to blink red
 Select TAKE
• The salvo is executed
• The FUNC button turns off
• The front panel returns to normal operation mode