Teac CD-200IL - Manual (Page 16)

16
TASCAM CD-200iL
3 – Preparations
Removing a dock adapter
As shown in the illustration below, insert a flathead screwdriver
into the hole in the dock adapter and then use the driver to
remove the adapter.
CAUTION
• When removing the dock adapter, use a hand to hold the
iPod dock in place.
• Do not move the iPod dock left, right, up or down when it is
pulled out.
Removing the iPod or iPhone
• Before connecting or disconnecting an iPod or iPhone, set
the current source to
-CD-
or
-AUX-
(not
-DOCK-
) or
turn this unit off.
• In order to avoid applying excessive force when connecting
or disconnecting an iPod or iPhone, align it with the Dock
connector and proceed gently. Refer to the illustration
below.
Direction of iPod/iPhone insertion and removal
Connecting external audio players
By connecting the analog output (line out or headphones jack)
of another type of audio player or an iPod/iPhone that does not
have a Lightning or Dock connector to the AUX IN jack on the
front of this unit, you can output sound from these audio players
through the output jacks of this unit. Since the AUX IN jack does
not have an input level adjustment, adjust the output level from
the connected device.
CAUTION
• Minimize the volume of an external device before
connecting it to the AUX IN. Failure to do so could cause a
sudden burst of loud noise, which might result in hearing
damage, for example.
• Before connecting or disconnecting with the AUX IN jack,
set the current source to
-CD-
or
-DOCK-
(not
-AUX-
) or
turn this unit off.