Teac RC-601MKII - Manual (Page 22)

22
TASCAM RC-601MKII
FUNCTIONS USING CUE POINTS (CUE1 to CUE10)
Confirming the Time of Cue Points
The CHECK key can be used to check the time of currently
registered cue points and memo points.
1 When the memo mode is OFF (MEMO indicator is out),
press the CHECK key.
Each press of the CHECK key displays the following:
each of the cue points (1 to 10)
⇒ last auto-registered
cue point ⇒ current time.
Clearing Cue Point Settings
There are two ways of clearing currently set memo points.
Method 1
1 While disc operations are stopped, press the SET key
to set the remote control unit to the set mode. (The
indicator is lit.)
2 Press the key (0 to 9) of the cue point whose settings are
to be cleared.
This clears the cue point settings, and the indicator of the
cue point goes out.
The SET indicator goes out.
Method 2
1 When the memo mode is OFF (MEMO indicator is out),
use the CHECK key to display the setting of the memo
point to clear.
2 Press the CLR key.
This clears the cue point settings, and the indicator of the
cue point goes out.
Flash Start
The flash start setting allows you to instantly play back from
a preset cue point.
1 Set the cue point. (→ page 21 “Setting Cue Points”)
2 In the monitor PAUSE mode, press the FLASH READY
key.
The playback data at the start section of the cue point is
read to buffer memory on CD-601MKII. While the data
is being read, the FLASH READY indicator blinks, and
the message “DATA LOAD XX” (XX: cue point No.) is
displayed in the display window. When reading ends, the
FLASH READY indicator stops blinking and lights.
[NOTE]
• During reading, operation of keys other than the STOP
key is not accepted. When the STOP key is pressed,
reading is canceled, and the FLASH READY goes out.
3 Press the FLASH MODE key to set the remote control
unit to the flash start mode. (The FLASH MODE indicator
blinks.)
4 Press the numeric key of the currently set cue point.
This starts playback instantly from the cue point.
When a numeric key is pressed in the online READY
mode or online playback mode, the remote control
unit enters the online playback mode regardless of the
failsafe function setting. When a numeric key is pressed
in the monitor PAUSE or monitor playback mode, the
remote control unit enters the monitor playback mode.
5 To cancel the flash start mode, press the FLASH MODE
key again.
[NOTE]
• To cancel flash ready, hold down the FLASH READY
key in the monitor PAUSE mode. “CLEAR FLASH” is
displayed in the display window, and the FLASH READY
indicator goes out.
• In the flash start mode, other functions (e.g. index search
by numeric keys, time search, direct cue point search)
that use the numeric keys cannot be used.
• The flash start mode can be entered only when the
FLASH READY indicator is lit. Otherwise, this mode
cannot be entered.
• New cue points cannot be set while the FLASH READY
indicator is lit.
RC-601MKII_Eng.indd 22 3/24/2005 2:38:21 PM