Teac RC-601MKII - Manual (Page 26)

26
TASCAM RC-601MKII
OTHER FUNCTIONS & SETTINGS
Displaying the End of Track Warning
The end of track warning (EOM = End of Message) can be
displayed in the display window in the online playback and
monitor playback modes. (In the default setting, the warning
is not displayed.)
When the end of track warning is set to be displayed, the
countdown to the end of the track is displayed.
Set the end of track warning display using menu No. 11
(“EOM”).
OFF (default setting): The end of track warning is not
displayed.
10, 15, 20, 30, 60, 90: The countdown display starts
from the end of the track by the
preset number of seconds.
Checking the Ending of Tracks
When the END CHECK key is pressed to turn the end
check function ON (indicator lights), the ending of the track
can be monitored. This feature is handy for checking how
tracks end.
1 Set the desired check time using menu No. 12 (“E_CHK”).
The ending section of the track can be monitored for the
preset time.
Set within the range 5 to 30 seconds in 1-second
increments. The default setting is 5 seconds.
2 Press the END CHECK key to turn the end check
function ON (indicator is lit).
3 While disc operations are stopped, in the monitor
playback mode, or in the monitor PAUSE mode, select
the track to check using the TRACK key.
While disc operations are stopped or in the monitor
playback mode, monitor playback is performed for the
preset end check time.
In the monitor PAUSE mode, playback stands by in the
monitor PAUSE mode at the position for the amount of
the preset end check time.
To turn the end check function OFF:
Either press the END CHECK key, or press the READY or
STOP key.
[NOTE]
• When a track is selected in the monitor PAUSE mode,
the remote control unit enters the monitor PAUSE mode
at the point on the track before the amount of the preset
end check time.
• When a track is selected by using the TRACK key on the
CD-601MKII, the end check function does not work.
Switching the Time Display
Each press of the DISPLAY MODE key during playback
switches the time information in the display window. As the
default setting, the time display mode is switched between
“track elapsed time” and “track remaining time.”
The type of time display that is switched using the DISPLAY
MODE key can be selected in menu No. 19 (“TIME”).
Selections are displayed at 1 to 4.
1 (default setting): Track elapsed time ⇔ track remaining
time
2: Track elapsed time ⇔ track remaining time ⇔ disc
remaining time
3: Track elapsed time ⇔ track remaining time ⇔ disc
remaining time ⇔ disc total time
4: Track elapsed time ⇔ track remaining time ⇔ disc
remaining time ⇔ disc total time ⇔ track time
The current time display mode is displayed as follows at the
top of the display window.
Track elapsed time: (no display)
Track remaining time: REMAIN is lit.
Disc remaining time: TOTAL REMAIN is lit.
Disc total time: TOTAL is lit.
Track time: TOTAL blinks.
z The time display setting is backed up on the remote
control unit. So, the same setting is reproduced when the
remote control unit is next turned ON.
[NOTE]
• While disc operations are stopped, the disc total time is
displayed.
• Selection of the time display mode by the DISPLAY
MODE key is applied only on the RC-601MKII. For
selection of the time display mode on the CD-601MKII,
the DISP MODE key on the CD-601MKII is used. Note,
however, that the menu No. 19 (“TIME”) setting is valid
on both the RC-601MKII and the CD-601MKII.
RC-601MKII_Eng.indd 26 3/24/2005 2:38:30 PM