Teac RC-601MKII - Manual (Page 3)

TASCAM RC-601MKII
3
INTRODUCTION
Before you start using this product, thoroughly read and
understand this manual. After you have finished reading this
manual, be sure to keep it in a safe place so that it can be
retrieved whenever necessary.
The RC-601MKII is the remote control unit exclusively
for the CD-601MKII. Connecting the RC-601MKII to the
CD-601MKII not only allows you to use lots more functions
but also makes operation of the CD-601MKII easier.
MAIN FUNCTIONS/ADDITIONAL
FUNCTIONS
The following functions can be expanded and added on to
the CD-601MKII by connecting the RC-601MKII:
z Time chart/index search using the numeric keys
z Search using the jog/search dial
z End check function that allows you to listen to the end of
tracks
z Various repeat playback functions (1 tune repeat, all
tunes repeat, program repeat, repeat playback between A
and B)
z Cue point locate function. Up to ten cue points can be
registered to each disc.
z Instant start from cue point (flash start function)
z Cue point settings for 500 discs can be stored to
memory.
z Playback between memo points (A and B)
z Monitoring of output from up to four external audio
equipment on headphones
About Terms Used in This Manual
This manual uses the following terms:
“Online READY” is used to indicate an “online playback
standby state” and
“Monitor PAUSE” is used to indicate a “monitor playback
standby state.”
CAUTION
Before connecting or disconnecting the connector cable to
or from the CD-601MKII, first turn the CD-601MKII OFF.
Connecting or disconnecting the connector cable with the
power turned ON may cause the remote control unit to
malfunction.
Product Configuration
This product comprises the following:
• RC-601MKII unit x 1
• Connector cable (5 m) x 1
• Owner’s Manual (this manual) x 1
• Warranty
x 1
When unpacking this product, take care not to damage the
product. Store the box and packaging materials so that they
can be used for transporting the product at a later date.
If you find that any parts are missing or parts have been
damaged during transportation, contact your dealer
immediately.
CD-601MKII Operation Settings
Operation on the CD-601MKII can be selected between
enabled and disabled when the RC-601MKII is connected.
Set enable/disable using menu No. 17 (“RMT”).
R_L (Remote + Local): Operation is possible on both the
RC-601MKII and the CD-601MKII.
R (Remote): Operation is possible on only the RC-601MKII.
Operation of the CD-601MKII by keys other than the
OPEN/CLOSE and DISP MODE key is disabled.
* For details on menu operations, see “Menu Operations”
(page 13).
About Backup Memory
The following setup information is stored to backup
memory on the CD-601MKII so that the same settings are
reproduced when this product is next turned ON.
• Playback mode
• Time display mode
• Auto ready function ON/OFF
• Auto cue function ON/OFF
• Pitch control function ON/OFF
• Pitch control value
• Index search function ON/OFF
• Settings for each of the menu items (*)
(*): When the “USER” menu is set to “PRE”, the menu item
settings return to their defaults each time that the power
is turned ON. (
→ page 15 “Saving Menu Settings”)
RC-601MKII_Eng.indd 3 3/24/2005 2:38:11 PM