Teac CD-RW750 - Manual (Page 15)

TASCAM CD-RW750 Owner’s Manual
15
3 – Playback operations
The CD-RW750 can be used to play back CDs
(including CD-R and CD-RW discs that have been
recorded and finalized on other types of recorder), as well as CD-R discs and CD-RW discs that have been
recorded on the unit.
Simple playback operations
1 Press the OPEN/CLOSE key (
3
or
1
) to open
the disc tray.
2 Discs should be inserted in the tray with the
label uppermost.
3 Press the OPEN/CLOSE key (
3
or
1
) to close
the tray again.
When a disc is loaded into the unit, the display
briefly shows
TOC Reading. , with a flashing
period following the word “Reading” as the unit
determines the contents of the disc. When the TOC
has been read, the display shows the total running
time of the disk, followed by the disc title (if the disc
contains CD TEXT information), followed by the
total running time.
If the title of the disc is more than 12 characters long
(a disc title can be up to 23 characters long), only the
first 12 characters are displayed.
The first 12 characters of the disc title are also shown
(for three seconds) when playback is stopped.
In stop mode, no digital output is possible (see “Input
monitoring” on page 18).
The CD-RW750 also shows (at the top left of the dis-
play) one of the following:
1 Press the PLAY key ( I or L ) to start play-
back
2 Press the STOP key ( H or J ) to stop play-
back
3 Press the PAUSE key ( J or K ) to pause play-
back temporarily.
The track number indicators at the bottom of the dis-
play light, to show the available unplayed tracks. If
there are thirteen tracks on the disc, for example,
indicators
1 through 13 will light. If there are more
than 20 tracks on a disc, the track number OVER indi-
cator (at the bottom of the display) will light.
Track titles If the finalized disc contains CD
TEXT information, the first 12 characters of the track
title (track titles can be up to 23 characters in length)
are shown for about two seconds, about three sec-
onds into the track.
Time display modes
When playing back a CD (or in pause mode), there
are five different display modes.
In each time mode, the current track number is given,
followed by the time, as given below, e.g.
10 Tr 0:48
Press the DISPLAY key (
A
or ) to cycle through
these time display modes, as described below:
NOTE
If programmed playback has been selected (“Pro-
grammed order playback” on page 17), the elapsed
time and total remaining time refer to the programmed
material, not the whole disc.
CD A commercial pre-recorded CD or a finalized
CD-R
CD-R, NO TOC A CD-R which has yet to be finalized
CD-RW, NO TOC A CD-RW which has yet to be finalized
CD-RW A finalized CD-RW (this differs from a CD, as it
may be unfinalized and erased)
[blank] Unusable or unreadable disc or no disc
Display shows Meaning
TOTAL Total elapsed time of the disc
[blank] Elapsed time of the current track
TOTAL REMAIN Time remaining of the current disc
REMAIN Time remaining of the current track
[track title] If the disc contains CD TEXT information, the
current track title is shown. If the title is longer
than 12 characters, is scrolls across the display.