Teac CD-RW750 - Manual (Page 23)

4 – Recording
TASCAM CD-RW750 Owner’s Manual
23
To enable or disable automatic track division:
1 With a recordable disc inserted, and with the
unit in record ready mode, press the
MENU
key ( 9 or 6 ) repeatedly until
A_Track>XX is shown, where XX may be
ON or OFF .
2 Turn the MULTI JOG control B or use the
SKIP keys I to change the value to ON or
OFF .
The A-TRACK indicator at the top right of the
display lights when the auto track function is
enabled.
Automatic track division can be turned on or off
while recording is taking place.
NOTE
When recording certain types of material (e.g. certain
types of classical music or spoken word) through the
analog or non-DAT/CD/MD digital connections, since
the track divisions are determined by relative silence, it
is possible that spurious track divisions will be inserted.
Under these conditions, it may be better to use manual
track division (see below).
However, if recording through a DAT/MD/CD digital
connection, the track number will be incremented only
when a track division signal is received, followed by a
rise in volume.
Digital direct
As mentioned earlier, the digital direct mode
bypasses some of the input circuitry of the CD-
RW750 (the frequency converter and the digital level
control) to write directly to the disc.
To enable or disable digital direct recording:
1 Ensure that the input source is set to DIGITAL
(either COAXIAL or OPTICAL ).
2 Press the DIGITAL DIRECT key 5 (main unit
only). The display shows D_Direct XX
where XX is ON or OFF .
3 Press the DIGITAL DIRECT key to toggle
between ON and OFF .
When digital direct recording is enabled, the
DIGITAL indicator in the display flashes slowly.
NOTE
As mentioned earlier, the digital direct feature bypasses
the frequency converter. Recording is therefore only
possible from sources recorded with 44.1 kHz sampling
frequency.
Rec mute function
The rec mute function allows instant cut-off of the
input signal, and records four seconds of silence on
the disc.
1 While recording is in progress, press the REC
MUTE key G .
The display shows REC MUTE , the meters
stop displaying the current level and the moni-
tored sound is cut.
2 After about four seconds, the unit enters
record ready mode.
NOTE
This function is only available from the remote control
unit. It is not possible to use this function with the main
unit only.
Fade-in and fade-out
To provide smooth beginnings and endings to
recorded tracks, the unit provides fade facilities.
Fade-ins are from –
∞ (silence) to the set input level
(“Input selection” on page 18) and fade-outs go from
the current input volume to silence.
The fade-in and fade-out times can be set indepen-
dently in increments of one second, from 1 second to
24 seconds.
level
time
S_LVL
Track incremented
Track start signal
received