Teac CD-RW750 - Manual (Page 27)

5 – After recording
TASCAM CD-RW750 Owner’s Manual
27
1 With the disc loaded, and the unit in stop
mode, press the
ERASE key ( G or D ).
2 Turn the MULTI JOG control B or use the
SKIP keys I until the display shows DISC
REFRESH .
3 To refresh the disc, press the MULTI JOG con-
trol or press the ENTER key 7 .
NOTE
This operation cannot be undone. If you are going to
refresh a disc, make sure that it contains only recordings
that you really want to erase!
4 If you do not want to proceed with the refresh
operation, press any other key (such as the
STOP key).
5 If the erase operation has been selected, the
word
ERASE flashes on the display, and the
timer starts counting down. The refresh oper-
ation typically takes around 40 minutes or so.
6 At the end of the countdown period, the word
Complete appears briefly on the display,
and the display returns to the track/time
display (of course, there are no tracks, and the
disc is as the start, with the total time of the
disc available for recording).
Titling (CD TEXT)
The CD-RW750 allows you to add titles to discs and/
or tracks on the disc which can be read and displayed
by suitably-equipped players (naturally, the CD-
RW750 is itself such a player, capable of reading and
displaying CD TEXT—see “Simple playback opera-
tions” on page 15 and “Time display modes” on
page 15).
Up to 23 alphanumeric characters (including space)
may be written in a title. One title may be written per
disc and per track (for example, it is not possible to
enter the disc title and artist as separate titles).
NOTE
Titling can only be carried out on an unfinalized record-
able disc, and the titles only become readable by a
player after the disc has been finalized.
This is a menu option, accessed in the following way
(this describes the operation from the main unit—
you can also use the
SKIP keys of the remote control
unit rather than turning the MULTI JOG control, and
the ENTER key of the remote control unit rather than
pressing the MULTI JOG control).
1 Press the MENU key until the display shows
CD TEXT? . Press the MULTI JOG control.
2 The display shows T_EDIT DISC? . To
edit the disc title, press the MULTI JOG con-
trol, or to start editing the track titles, turn the
control so that the display shows
T_EDIT>01 Tr .
Continue turning the control to select the
track whose title will be edited, and press it
when the number of the track whose title will
be edited is displayed.
3 Use the MULTI JOG control both to enter char-
acters (uppercase and lowercase letters, num-
bers, and symbols) and to move the entry
cursor.
Change between these two cursor modes with
the
FADER (JOG MODE) key,
• When the MULTI JOG is used for data entry,
the cursor is a flashing underline (changing
to data entry mode inserts a space at the
cursor). Turn the control to select the char-
acter, and push it to confirm the entry and
move to the next character position.
• When the MULTI JOG is used for cursor
movement, the cursor is a steadily-lit under-
line.
• Use the ERASE/DEL key to delete characters
at the cursor.
• Change between uppercase and lowercase
letters using the
DISPLAY key. When upper-
case is selected, CAPS is shown in the display.
4 Press the FINALIZE/YES key to finish editing
the title. The display shows Writing fol-
lowed by Write OK and returns to
T_EDIT . From this step, you can then select
another title to edit.
5 Press the STOP key when all titles are finished.
6 Finalize the disc (see “Finalizing” on page 25).