Teac CD-RW750 - Manual (Page 26)

5 – After recording
26
TASCAM CD-RW750 Owner’s Manual
Erasing tracks
It is possible to erase the last recorded track, the last
two recorded tracks, the last three recorded tracks,
etc. It is not, however, possible to erase tracks in the
“middle” of the disc.
1 With the disc loaded, and the unit in stop
mode, press the
ERASE key (
G
or
D
).
2 If the display does not show ERASE XX-
XX? , where XX is the number of the last
track recorded on the disc, turn the MULTI
JOG control B or use the SKIP keys I until
it is displayed.
3 Turn the MULTI JOG control or use the SKIP
keys to change the number of the first track to
be erased. The highest value that this number
can take is the last track recorded (e.g. if 17
tracks have been recorded on the disc,
17-
17 means that the last track only, 17, will be
erased). The lowest value that this number can
take is
2 (if this number was 1 , the whole disc
would be erased, as described below).
NOTE
If only one track has been recorded on the disc, only the
“erase disc” option (“Erasing a whole disc” on page 26)
is available.
4 When the range of tracks to be erased has
been selected, press the
MULTI JOG control or
press the ENTER key 7 .
NOTE
This operation cannot be undone. If you are going to
erase a track or tracks, make sure that they are record-
ings that you really want to erase!
5 If you do not want to proceed with the erase
operation, press any other key (such as the
STOP key).
6 If the erase operation has been selected, the
word
ERASE flashes on the display, and the
timer starts counting down from 0:20 (20
seconds).
7 At the end of the countdown period, the word
Complete appears briefly on the display,
and the display returns to the track/time
display.
Erasing a whole disc
When you want to erase a whole disc (all the tracks
on a disc), follow the procedure below:
1 With the disc loaded, and the unit in stop
mode, press the
ERASE key ( G or D ).
2 Turn the MULTI JOG control B or use the
SKIP keys I until the display shows ERASE
DISC? .
3 To erase the contents of the disc, press the
MULTI JOG control or press the ENTER key
7 .
NOTE
This operation cannot be undone. If you are going to
erase a disc, make sure that it contains only recordings
that you really want to erase!
4 If you do not want to proceed with the erase
operation, press any other key (such as the
STOP key).
5 If the erase operation has been selected, the
word
ERASE flashes on the display, and the
timer starts counting down a time value shown
on the display.
6 At the end of the countdown period, the word
Complete appears briefly on the display,
and the display returns to the track/time
display.
Refreshing a disc
If a CD-RW disc has been corrupted at any point (e.g.
power has been cut off in the middle of a finalize
operation, etc.), or has been used in a computer or
another piece of equipment that makes it unreadable, it is possible to “refresh” the disc to make it usable
again. This is equivalent to formatting a disk on a
computer to prepare it for use. This operation
destroys all data on the disc.