Teac G-01 User Manual
Page 9
9
En
gl
is
h
A
10 MHz OUT connectors
These output 10 MHz clock signals (sine wave, 0.5 Vrms output
level, 50 Ω output impedance).
Connect these 10 MHz OUT connectors to the clock sync input
connectors or word sync input connectors of CD players, D/A
converters and other digital devices that support 10 MHz input
using standard BNC coaxial cables (50 Ω impedance).
0
Use the 10M OUT connector setting (10MOUT>***) to turn
10 MHz output ON/OFF (see page 17).
B
Reference frequency input connector [EXT IN]
To input an external reference signal generator (10 MHz output)
or GPS receiver (1 pps/10 MHz output), connect the output con-
nector of the reference signal generator/GPS receiver to this EXT
IN connector using standard BNC coaxial cables (50 Ω imped-
ance) (see pages 11-12).
0
If the output level of the external oscillator is outside the
allowable input range of this unit, it cannot be used. Refer to
the oscillator manual for information on the output level and
accuracy of the oscillator.
C
Ground connector [SIGNAL GND]
Audio quality might be improved by making ground connections
with connected devices such as digital equipment and amplifiers.
0
This is NOT an electrical safety ground.
D
CLOCK OUT connectors
These output clock signals (square wave, TTL level, 75 Ω output
impedance).
Connect these CLOCK OUT connectors to the clock/word sync
inputs of CD players, D/A converters and other digital equipment
using standard BNC coaxial cables (75 Ω impedance).
0
Use the A, B and C buttons on the front panel to change their
frequencies (see pages 11-12).
0
Use the frequency mode setting (FREQ) to set the clock refer-
ence frequency (see page 17).
E
AC power inlet
Connect the included power cord to this inlet. After completing
all other connections, plug the power plug into the AC power
outlet.
0
This unit uses a 3-pin power cord socket, but the grounding
pin does not connect to the chassis of the unit.
V
Use only the supplied Esoteric power cord.
Use of other power cords could result in fire or
electric shock.
Unplug the power cord from the outlet when
you are not planning to use the unit for an
extended period of time.
At Esoteric, we use Esoteric MEXCEL stressfree cables for reference.
For detailed information, access the following website.