Thinklogical Remote Power Distribution Unit 4/4 Manual - Manual (Page 12)

®
PDU 4/4 Product Manual September, 2014 Page 11
The following commands are in alphabetical order. Do not type the angle brackets < > when entering data.
PDU 4/4> help buttons
Syntax buttons <b> <e | d>
Description: Enable or disable front panel button control.
<b> = (box # | all) <d> = disable <dly> = delay <e> = enable
<n> = name <t> = time <p> = (port # | name | all)
Examples:

Enable Front Panel Button control on Box 1 buttons 1 enable

Disable Front Panel Button control on all PDU 4/4s buttons 0 disable
history – Display Command History
The history command will show the past 16 commands. This data is not stored in non-volatile memory.
PDU 4/4> help history
Syntax: history
Description: Display previous command history.
<b> = (box # | all) <d> = disable <dly> = delay <e> = enable
<n> = name <t> = time <p> = (port # | name | all)
name - Define Port Names
The name command allows the user to assign names to each of the ports. Ports with identical names are grouped
together since commands can be issued to control the boxes by name or by port number.
The Port Names can be changed to any string of 1 to 16 characters (including all printable characters) not including
‘space’ or ‘comma’. Port names cannot start with a number.
PDU 4/4> help name
Syntax: name <b> <p> <n>
Description: Max.16 alphanumeric characters. The name must not start with a number.
<b> = (box # | all) <d> = disable <dly> = delay <e> = enable
<n> = name <t> = time <p> = (port # | name | all)
Ports and Boxes may be referred to by all, name (implying a group) or number.
Ranges of ports may be specified as 1-4 = 1,2,3,4. All may also be used.
The Define Port Names command allows the user to give each port an alias and allows the grouping of outlets. The
Port Number is not changed or affected by renaming the port, and may always be used to control the port.
Examples:

name 1 Sun 1,3,5 assigns the alias of Sun to Box 1, Ports 1, 3, and 5

name 0 Sun 1-4 assigns the alias of Sun to all Boxes, ports 1 through 4

name 0 Sun ALL assigns the alias of Sun to all Boxes, all ports
Default names are ‘DEVICE1’ through ‘DEVICE8’ for Ports 1-8, respectively.
Port Names must be between one and sixteen characters , and can include any printable characters except for ‘space’
or ’comma’. Port names cannot start with a number.
Port Groups
Port Groups can be created and controlled by assigning identical names to two or more ports. All ports with identical
names within one PDU 4/4 are grouped together provided the user enters an operational command for that name.
All ports with identical names in ALL daisy-chained PDU 4/4 chassis will be controlled provided the user enters a
valid GLOBAL (box ID = 0) command.