Verilink DIU 2131 (880-502765-001) Product Manual - Manual (Page 29)

Index
Verilink User Manual Index-1
A
alarms
LOS 3-5
applications using
devices with synchronous connections 2-1
B
battery, clock chip iii
block error counter 4-3
command for 4-3
C
C command 3-4
channel assignment 3-3
Clear To Send 3-5, 4-4, 4-5
See also CTS
command summary
DIU 2130 Menu 3-4
commands
C, assign DIU to CSU 3-4
D, assign DS-0 channels 3-4
E, enable DTE loop 3-5
F, set far data channel loop 3-5
G, LOS lead 3-5
K, data input clock 3-4
M, data transmission mode 3-4
N, set near data channel loop 3-5
P, monitor leads and status 3-5
S, scramble data stream 3-4
T, port for timing 3-4
T, test and monitor BEC 3-5
CTS 3-5, 4-4
See also Clear To Send
D
D command 3-4
Data Carrier Detect 3-5, 4-4
See also DCD
Data Carrier Equipment 4-4
Data Set Ready 3-5, 4-4
See also DSR
Data Terminal Equipment 4-4
Data Terminal Ready 3-5, 4-4
data transmission mode 3-4
DCD 4-4
See also Data Carrier Detect
DIU
configuration settings 3-2
data transmission mode 3-4
timing source 3-4
DIU 2130 2-3, 3-1
assigning to CSU 2-3, 3-2, 3-4
clocking 3-4
enable loop 3-5
menu layout 3-2
near loopback 3-5
port assignment 3-4
statistics 3-2
DSR 4-4
See also Data Set Ready
DTR 3-5, 4-4
See also Data Terminal Ready
E
E command 3-5
enable loop command 3-5
errors
far loopback failure 3-4
F
F command 3-5, 4-3
far loopback command 3-5
G
G command 3-5
I
INV-ST 3-4
See also inverted timing
K
K command 3-4
L
LEDs
for troubleshooting 4-1
LL 4-5
See also local loop
local loop 4-5
Loopbacks
for troubleshooting 4-1
loopbacks, DIU 2130
enable DTE loop 3-5
enable loops 3-5
far data channel loop 3-5
far loopback 3-5
near data channel loop 3-5
near loopback 3-5
Loss of Signal 3-5
LOS alarm 3-5
LOS lead command 3-5
M
M command 3-4
monitor leads and status command 3-5
mux mode
channel agreement 3-3
validating the configuration 3-3