Verilink PRISM 3001 (34-00186) Product Manual - Manual (Page 15)

2
I
NSTALLATION
Introduction This chapter contains information and instructions required to prepare the TxPORT
PRISM 3001 for use. Included are initial inspection procedures, mounting
instructions, configuration guidelines, connection instructions, and powering
information.
Throughout this manual, all factory default settings are shown underlined.
Safety
Summary This manual contains information and warnings which must be followed to ensure
safe operation and to retain the equipment in a safe condition.
The WARNING sign denotes a hazard to the operator. It calls attention to a
procedure or practice which, if not correctly performed or adhered to, could result in
injury or loss of life. Do not proceed beyond a WARNING sign until the indicated
conditions are fully understood and met.
Follow proper ESD (electrostatic discharge) procedures while handling the circuit boards.
Unpacking
and
Inspection This unit is carefully packaged to prevent damage in shipment. Upon receipt,
inspect the shipping container for damage. If the shipping container or cushioning
material is damaged, notify the carrier immediately and make a notation on the
delivery receipt that the container was damaged (if possible, obtain the signature
and name of the person making delivery). Retain the packaging material until the
contents of the shipment have been checked for completeness and the instrument
has been checked both mechanically and electrically.
If the contents of the shipment are incomplete or, if there is mechanical damage or
defect, notify TxPORT. If the shipping container is also damaged, or the
cushioning material shows signs of stress, notify the carrier of the damage as well
as TxPORT. Keep the shipping materials for carrier’s inspection. TxPORT will
arrange for repair or replacement without waiting for claim settlement.
Supplied
Materials The PRISM 3001 is shipped from the factory with the PRISM 3001 reference
manual.
The following additional materials may be required for the installation and
operation of the PRISM 3001.
✦ -48 VDC power source
✦ Network and DTE interface cables
✦ 20-gauge stranded wire (or similar) for DC power and alarm connection
!