Pogo pin docking cable – HP Spectre x2 User Manual
Page 38
POGO pin docking cable
Description
Spare part number
POGO pin docking cable (includes adhesive double-sided adhesive)
830335-001
Before removing the POGO pin docking cable, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
Display panel assembly on page 20
Remove the POGO pin docking cable:
1.
Remove the four Phillips PM1.5×3.8 screws (1) that secure the POGO pin docking cable to
the back cover.
2.
Disconnect the POGO pin docking cable (2) from the system board.
3.
Detach the POGO pin docking cable (3) from the back cover. (The display panel cable is attached to
the back cover with double-sided adhesive.)
4.
Release the POGO pin docking cable from the retention clips (4) built into the battery.
5.
Remove the POGO pin docking cable (5).
Reverse this procedure to install the POGO pin docking cable.
28
Chapter 5 Removal and replacement procedures