HP Spectre x2 - Manual (Page 54)

e. 3D camera board (see 3D camera board on page 34 )
f. System board (see System board on page 40 )
Remove the heat sink:
1. Following the 1 – 2 sequence stamped into the heat sink, remove the two Phillips PM2.0×2.5 screws (1)
that secure the heat sink to the system board.
2. Remove the heat sink (2).
NOTE: Due to the adhesive quality of the thermal material located between the heat sink and
the system board components, it may be necessary to move the heat sink from side to side to detach it.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and
the system board each time the heat sink is removed. Replacement thermal material is included with
the heat sink and system board spare part kits. Thermal paste is used on the system board (1) and
the section of the heat sink (2) that services it.
Reverse this procedure to install the heat sink.
44 Chapter 5 Removal and replacement procedures