HP Spectre x2 - Manual (Page 43)

Rear-facing webcam
Description Spare part number
Rear-facing webcam (includes cable and double-sided adhesive) 830349-001
Before removing the front-facing webcam, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 20 ).
Remove the rear-facing webcam:
1. Release the ZIF connector (1) to which the rear-facing webcam cable is attached, and then disconnect
the rear-facing webcam cable from the system board.
2. Detach the rear-facing webcam (2) from the back cover. (The rear-facing webcam is attached to
the back cover with double-sided adhesive.)
3. Remove the rear-facing webcam and cable.
Reverse this procedure to install the rear-facing webcam.
Component replacement procedures 33