ACTi Camera Firmware V.5.12.12 - Manual (Page 22)

www.acti.com
Firmware User ’s Manual V5.12.12
22
Date Setting
Parameters Description
SNTP/NTP
server
Click this to enable IP device’s SNTP/NTP function. This enables this IP
device to synchronize its time settings with a SNTP/NTP server. You can
use this function to make sure all your IP devices’ time is the same.
Additionally, with our embedded digital-time-code in the streaming, you
can tell the event sequence accurately.
IP address : Enter the IP address of the SNTP/NTP server.
Sync time : Select the time interval for this IP device to synchronize
its time.
Set manually
Click this to manually setup the date & time.
Date : Select the date
Time : Select the time
Time zone
Select the time zone offset for local settings
Day Light
Saving
Select Type 1 to specify daylight saving time by week number in a
month; select Type 2 to specify daylight saving time by date.
Start Time : Select the daylight savings start time.
End Time : Select the daylight savings end time.
Click the [Apply] button to confirm the settings or click the [Reset] button to re-enter
the parameters.