Network settings – ACTi ENR-1000 User Manual
Page 52
Advertising
ENR-
1000 Series System Administrator’s Manual
Network Settings
There are two network interface cards in ENR. Either of these cards can be supported by the
built-in DHCP server feature, which enables ENR to assign IP addresses to cameras via
LAN1
or
LAN2
port without another DHCP on router.
Go to
Setup
page
Network
tab
The current settings of both LANs will be displayed here.
By default,
LAN1
card is set to
Manual
mode with a fixed IP address
192.168.0.10
, while
LAN2
is in
DHCP
client mode. It is suggested that you connect
LAN1
to LAN and connect
LAN2
to WAN.
Advertising
This manual is related to the following products: