Archgard 31-DVIE33N - Manual (Page 19)

31-DVIE33
19
LOG PLACEMENT
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The Archgard pan burner bed and fiber logs are designed to give a realistic fire package, and
created to look the same as the day they were originally installed. Care must be given when
first installing the logs, and if removed for servicing, as they can be damaged or broken if not
handled properly.
After opening the log set package, inspect the logs to ensure that no damage has occurred
inside the package. Please report any damage immediately to your Authorized Archgard
Dealer.
Gas and vent connection must be made before installing the embers and logs on the pan
burner.
NOTE: Improper placement of logs and embers may cause soot accumulation on the internal
parts and glass. This is not covered under warranty. Do not use broken or damaged logs.
Locate the embers and logs and place them on their prospective locations. Refer to the pictured
instructions on the following pages that will show how to place all seven (7) logs. Pins and holes
must be aligned with logs and burner.
IMPORTANT: Embers should be placed so as not to completely block burner ports. Separate
the material and spread around the pan.
NOTE: Installing the fiber logs in any other position other than shown will result in flame
impingement causing sooting of the logs, brick liner and ceramic glass viewing area.
Locator Pins
LOCATOR PINS
BURNER AIR TRAY