Eneo EDC-3371 User Manual
Page 15
5
PRESET CAMERA SETUP
FOCUS
:
AUTO
MOTION
:
OFF
MOTION SETUP
AE SETUP
SAVE AND EXIT (ESC TO EXIT)
Follow steps below to store the Preset positions:
. Press the
PRST key to enter the preset menu directly. Or press the MENU key to display the main menu on the monitor. Scroll to preset and push the
Joystick to the right.
. Select the blank preset position to be stored by pushing the
Joystick up, down, right, or left.
3. After selecting a blank position, press and hold
CTRL, Use the Joystick to control the direction of the camera and lens.
4. After aiming the camera (view direction and lens control), release
CTRL. The cursor will be on the Title then twist the Joystick handle or Press Tele or
Wide Key to edit the preset title. Follow the procedure of the auto scan above to edit titles.
5. Select „CAMERA SET” and pushing the
Joystick left or right. Then the preset camera setup displays.
Set SENSITIVITY: ~0
Set POSITION: ALL, CENTER
Set DELAY: 0~5 SEC
Set OUTPUT: OFF, OUT~4
Set HOLD TIME: 3~99 SEC
Select „AE SETUP” and pushing the
Joystick left or right. Then the AE setup displays. Refer to the AE SETUP in the camera setup.
6. Set „DWELL TIME”(03-99second)
7. To select the next page of presets, scroll the page by pushing the
Joystick to the Left on the first and last columns of the menu.
8. Repeat steps through 7 for each additional preset position.
9. Select SAVE AND EXIT by pushing the
Joystick to the right. Press ESC to exit the Preset menu without saving.
NOTE: Press the HOME key at programmed preset position (*) to delete a programmed preset view.
The position, which is marked with *, already has the preset view assigned. To review the stored preset, press
PRST key on the *. The camera will show the
stored preset scene.
PRESET AREA SETUP
(CTRL KEY)
NUMBER 00
PAN
TILT
000.0
000.0
EXIT (ESC TO EXIT)
Hold down the
CTRL key while selecting the desired scene using the Joystick. Current position will be displayed. Release CTRL key to complete. Or Press
IRIS OPEN then the „CTRL” displays. Move the desired position and the zoom position. Press IRIS CLOSE then the „CTRL” disappears. Select Exit and push
the
Joystick to the right.
Set FOCUS: AUTO, MANUAL, ONE PUSH
Set MOTION: OFF, ON
Select “MOTION SETUP” and pushing the Joystick left or right. Then the MOTION setup displays.
MOTION SETUP
SENSITIVITY
:
POSITION
:
OFF
DELAY
:
00 SEC
OUTPUT
:
OFF
HOLD TIME
:
03 SEC
EXIT (ESC TO EXIT)