Eneo EDC-3371 User Manual
Page 27
7
This feature is useful to align a new dome camera exactly the same as the previously installed dome camera.
Dome camera’s origin set and all data initialize option do not override offset values. Only the default set option in this menu will set the offset value to
zero. This can be used to avoid ceiling obstructions.
• DOME RESET
OFFSET SETUP
(CTRL KEY)
PAN OFFSET:
000.0
TILT OFFSET:
000.0
ENABLE:
OFF
SAVE AND EXIT (ESC TO CANCEL)
• ORIGIN OFFSET
DOME RESET
ARE YOU SURE ?
CANCEL
OK
This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset value is not affected by this function.
(Offset is still valid after origin set)
• SYSTEM MENU
SYSTEM MENU
MOTOR SETUP
PASSWORD EDIT
ORIGIN CHECK
CALIBRATION:
ON
PASSWORD ENABLE:
OFF
MENU TIME OUT:
OFF
BLINK CURSOR:
ON
DOME ANSWER:
ON
SAVE AND EXIT (ESC TO CANCEL)
CALIBRATION
ON (Auto origin check) / OFF
PASSWORD ENABLE
ON (requires the password to enter menu) / OFF
MENU TIME OUT
ON (5 minutes) / OFF (always menu display)
BLINK CURSOR
ON / OFF (no blinking cursor)
DOME ANSWER
ON / OFF (no acknowledge command from the dome)
This option is helpful to escape the collision of the command using some DVR.