Eneo EDC-3371 - Manual (Page 7)

7
Figure 5 - Layout of Switches
3.3 Setting Dome Camera Termination
The device which is connected at end of line, whether it be a dome camera or keyboard controller, must have the cable for communication terminated by
setting the appropriate DIP switch. Without proper termination, there is potential for control signal errors. Total length of the cable for communication should
not exceed .km.
SW1 1 2
Terminated ON ON
Not terminated OFF OFF
Figure 6 - Setting Dome Camera Termination
SW: Termination switches
SW: Fail-Safe Network
Addresses (ID) and protocol
selection switches
1 2
ON
SW1