Eneo EDC-3371 - Manual (Page 9)

9
3.5 Setting Dome Camera Address (ID)
To prevent damage, each dome camera must have a unique address (ID). When installing multiple dome cameras using a multiplexer, it is suggested that the
dome camera address matches the multiplexer port number.
If you wan to set the address more than 999, you should connect the service provider.
Example: Port  = Dome , Port  = Dome  ... Port 6 = Dome 6. If more than 6 dome cameras are installed using two or more multiplexers, ID of the
dome camera should be ID of MUX x No. of camera IN. (e.g. multiplexer ID= n, Camera IN= m then ID of Dome =6x (n-) +m)
Refer to Figures 4-5 for setting the dome camera address (ID) and protocol selection.
Figure 9 - Setting Dome Camera Address (ID)
Dome ID S3 S2 S1
1 0 0 
2 0 0 
… … … …
999 9 9 9