Chapter 4 starting and configuring the firewall, 1 setting up the configuration environment, 1 connecting the firewall to the console terminal – H3C Technologies H3C SecPath F100-C-EI User Manual
Page 40: 2 setting terminal parameters, Chapter 4 starting and configuring the firewall -1, 1 setting up the configuration environment -1, 2 setting terminal parameters -1
Advertising
Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 4 Starting and Configuring
the Firewall
4-1
Chapter 4 Starting and Configuring the
Firewall
4.1 Setting up the Configuration Environment
4.1.1 Connecting the Firewall to the Console Terminal
For how to connect the firewall to the console terminal, refer to
section 3.5 “Connecting Interface Cables” on page 3-8.
4.1.2 Setting Terminal Parameters
1) Set up a HyperTerminal connection. Select Start > All
Programs
> Accessories > Communications >
HyperTerminal
, type a connection name as shown in
Figure 4-1, and click OK.
Advertising