H3C Technologies H3C SecPath F100-C-EI - Manual (Page 78)

Installation Manual
H3C SecPath F100-C-EI Firewall
Chapter 6 Troubleshooting
6-1
Chapter 6 Troubleshooting
6.1 Troubleshooting the Power System
Symptom:
The PWR LED does not light up.
Troubleshooting:
Check that:
z
The power switch of the PSU is turned on.
z
The power cord is connected correctly.
z
Correct mains supply is used.
Caution:
Do not plug or unplug the power cord with the firewall switched on.
Contact your local dealer if the PWR LED does not light up after the
above operations.
6.2 Troubleshooting Configuration System
After the firewall is powered on and the system is normal, the
startup information will be displayed on the console terminal. If the
configuration system has any faults, the console terminal may display
nothing or illegible characters