H3C Technologies H3C Intelligent Management Center - Manual (Page 102)

The Configure VLAN Mapping option exists if you selected a physical CE when you added an AC.
It does not exist if you selected only VCEs.
5. Click Next.
The CE Configuration page appears if you selected the Configure VLAN Mapping option, or the
Configuration Summary page appears if you did not select the Configure VLAN Mapping option.
Configuring CEs
1. Click Add under VLAN Mapping List, and configure the following settings in the popup window:
{
Device Label—Select a device label.
{
Interface Description—Enter a description for the interface.
{
VLAN Mappings—Enter a CVLAN-SVLAN mapping.
2. Click OK.
You can repeat the above steps to add more VLAN mappings.
3. Click Next to enter the Configuration Summary page.
Deploying the PBB VPN
1. Verify the VPN, PE, and CE settings in the Configuration Summary page.
2. Select Deploy Immediately.
3. Click OK to view the deployment result.
IMC deploys your settings to devices. If you did not select Deploy Immediately, IMC only
generates VPLS VPN information and commands, but does not deploy the settings to devices.
Undeploying VPNs
You can undeploy a VPN, or the PEs and ACs of a VPN from the network.
Undeploying a VPN
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Undeploy.
3. Click Select to select a VPN.
4. Select Undeploy VPN from the Operation list.
5. Click Next.
6. Verify the VPN settings on the Configuration Summary page.
7. Select Also Delete VPN to delete the VPN information.
If you do not select Also Delete VPN, the system will keep the VPN information.
8. Click OK to view the undeployment result.
Undeploying PEs
1. Click the Service tab.
92