H3C Technologies H3C Intelligent Management Center - Manual (Page 120)

The page for import results appears. You can see that the two PEs are imported.
Deploying a VPLS VPN
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy VPLSs.
The VPLS deployment guide page appears.
3. Define a VPN:
a. In the PE Type area, select PE.
b. In the VPN Configuration area, configure the following parameters:
− VPN Operation Type—Select Add VPN.
− VPN Name—Enter VPN name VPLS001.
− VSI ID—Use the default value.
− PW Transport Mode—Select VLAN from the list.
− Audit Interval (in hours)—Use the default value 24.
− Description—Enter This is a common VPLS VPN as the description.
− Contact—Use the default value admin.
c. Click Next.
4. Add the AC from CE 1 to PE 1:
a. Click Add on top of the AC List area.
The Select Interfaces window appears.
b. Select PE 1 in the Device List, and click OK.
The Interface List tab automatically appears.
c. Select Eth 1/1 that connects to CE 1, and click OK.
The Config UNI Interface page automatically appears.
d. Configure the following parameters:
− Service Instance—Enter service instance ID 1000.
− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from CE 1 to PE 1.
− Encap Type—Select S-VID from the list.
− Encap VLAN—Enter a value of 100.
− Access Type—Select VLAN from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select CE 1 and click OK to return to the Config UNI Interface page.
e. Click OK to return to the PE Configuration page.
5. Add the AC from CE 2 to PE 2 in the same way that CE 1-PE 1 AC is configured.
110