H3C Technologies H3C Intelligent Management Center - Manual (Page 26)

18
QoS function Subfunction Parameters
MatchRule
Type
• Any—Match all packets.
• Ipv4Acl—Use an IPv4 ACL as a match criterion.
• Ipv6Acl—Use an IPv6 ACL as a match criterion.
• IPv4Protocol—Use the IPv4 protocol as a match criterion.
• IPv6Protocol—Use the IPv6 protocol as a match criterion.
• Dscp—Use DSCP values as a match criterion.
• IpPre—Use IP precedence values as a match criterion.
• CustomerDot1p—Use customer 802.1p priority values as
a match criterion.
• MplsExp—Use MPLS EXP values as a match criterion for
MPLS packets.
• AtmClp—Use a CLP value as a match criterion for ATM
cells.
• FrDe—Use a DE value as a match criterion for Frame
Relay packets.
• SourceMAC—Use a source MAC address as a match
criterion.
• DestinationMAC—Use a destination MAC address as a
match criterion.
• QosLocalID—Use a local QoS ID as a match criterion.
• Classifier—Use an existing classifier as a match criterion.
• InboundInterface—Use an input interface as the match
criterion.
• RtpPort—Use an RTP port range as a match criterion.
• VlanID—Use VLAN IDs as a match criterion.
• ServiceVlanID—Use service provider VLAN IDs as a
match criterion.
• LocalPrecedence—Use local precedence values as a
match criterion.
• DropPriority—Use drop priority values as a match
criterion.
• Bittorrent—Use the BitTorrent protocol as a match
criterion.
• ServiceDot1q—Use service provider 802.1p priority
values as a match criterion.
• IPv4Address—Use IPv4 addresses as a match criterion.
• IPv6Address—Use IPv6 addresses as a match criterion.
• IPv4TCPPort—Use IPv4 TCP port numbers as a match
criterion.
• IPv6TCPPort—Use IPv6 TCP port numbers as a match
criterion.
• IPv4UDPPort—Use IPv4 UDP port numbers as a match
criterion.
• IPv6UDPPort—Use IPv6 UDP port numbers as a match
criterion.
• IPv4ACLName—Use an IPv4 ACL specified by its name
as a match criterion.
• IPv6ACLName—Use an IPv6 ACL specified by its name
as a match criterion.