H3C Technologies H3C Intelligent Management Center - Manual (Page 58)

50
• Description—Description of the classifier.
• IP Type—IP type for the classifier.
• Device Model—Device models that support the classifier.
Match criteria list contents
• Name—Name of the match criterion.
• Characteristics—Packet characteristics specified in the match criterion.
• Type—Type of the match criterion.
• Relation—Options are =(match) and !=(matchNot). If you select =(match), all packets meeting the
traffic characteristics are matched. If you select !=(matchNot), all packets failing to meet the traffic
characteristics are matched. If HP device models are included in the Select Model field, only
=(match) is available.
• Value—Value of the match criterion.
• State—Status of the match criterion. Options are Enabled or Disabled.
Adding a classifier
QoSM provides predefined classifiers. You can also add classifiers.
You cannot specify where to store a classifier when creating it. To add a classifier to a folder, first enter
the folder.
You cannot add a classifier to the predefined folder.
To add a classifier:
1. Access the classifier list page.
2. Click Add.
The Add QoS Classifier page appears.
3. Configure the basic information for the classifier:
{
Name—Enter a name for the classifier. The name can contain 1 to 31 alphanumeric and special
characters. Spaces and the following characters are not allowed:
\/:;*?"<>|
{
Rule Relationship—Specify the relationship among multiple match criteria. Options are:
− AND—Indicates that a packet is viewed as belonging to the classifier when it matches all of
the match criteria in the classifier.
− OR—Indicates that a packet is viewed as belonging to the classifier when it matches at least
one of the match criteria in the classifier.
{
Select Behavior—Select a behavior to be associated with the classifier.
{
IP Type—Select an IP type. Options are Undefined, IPv4, and IPv6. If HP device models are
included in the Select Model field, only IPv4 and IPv6 are available.
{
Description—Enter a description for the classifier.
{
Select Model—Select applicable device models for the classifier by using the following
procedure:
− Click Select Model next to the field.
The Select Model dialog box appears.
− In the Query Criteria area, enter a model name or system OID, and click Query.