H3C Technologies H3C Intelligent Management Center - Manual (Page 60)

52
Match Type Description Parameters
Priority
Use priority values as the
match criterion.
The additional parameters that need to be
configured vary by IP type and device model
configured when you add a classifier.
If you have configured the IP type as Undefined,
configure the following parameters:
• Priority Type—Select a priority type. Options
are IP-Precedence, MPLS-EXP, VLAN802.1p,
DSCP, and ServiceDot1p.
• Priority—Select one or more priority values by
clicking the icon.
If you have configured the IP type as IPv4 or IPv6 or
have selected HP device models, configure
additional parameters based on the configuration
of the Select IP MatchRule parameter:
• If you select Undefined for Select IP MatchRule,
no additional parameters need to be
configured. If you have selected HP device
models, the Undefined option is not available.
• If you select Match IPv4 Address or Match IPv6
Address for Select IP MatchRule, configure the
following parameters:
{
IPv4/IPv6 Source Address—Enter the IP
address of the packet sender.
{
IPv4/IPv6 Destination Address—Enter the IP
address of the packet receiver.
• If you select Match IPv4 TCP Port or Match IPv6
TCP Port for Select IP MatchRule, configure the
following parameters:
{
IPv4/IPv6 TCP Source Port Number—Enter
the TCP port number of the packet sender.
{
IPv4/IPv6 TCP Destination Port
Number—Enter the TCP port number of the
packet receiver.
• If you select Match IPv4 UDP Port or Match IPv6
UDP Port for Select IP MatchRule, configure the
following parameters:
{
IPv4/IPv6 UDP Source Port Number—Enter
the UDP port number of the packet sender.
{
IPv4/IPv6 UDP Destination Port
Number—Enter the UDP port number of the
packet receiver.
Any Match all packets.
No additional parameters need to be configured.
The =(match) option is selected for the Relation
parameter by default and cannot be changed.
Classifier
Use a classifier as the
match criterion.
Classifier name—Enter the name of an existing
classifier.
You can create new a match criterion by modifying
the Relation parameter of an existing classifier.