Requirements analysis, Qosm configuration analysis, Configuration procedures – H3C Technologies H3C Intelligent Management Center User Manual
Page 93: Adding classifiers
85
•
Deny traffic from the Administration department, HR department, and Finance department to the
computing server but permit their traffic to the FTP server.
•
Deny traffic from the R&D department to the file server but permit its traffic to the mail server and OA
server.
•
Deny traffic between the R&D department and all other departments.
•
Limit the bandwidths for traffic from FTP server to the Administration department, HR department,
and Finance department to 50 Mbps, 50 Mbps, 50 Mbps, respectively.
•
The traffic from the computing server should have higher priority to transmit on SWD.
Requirements analysis
•
Deny packets with destination IP address 192.168.2.7 on XGE 3/1/1 of the SWA (172.10.0.1).
•
Deny packets with destination IP addresses that belong to networks 90.16.50.1/24, 90.16.50.1/24,
and 90.16.50.1/24 on XGE 3/1/1 of the SWA (172.10.0.1).
•
Deny packets with destination IP address 192.168.1.3 on XGE 5/0/0 of the RTC (90.16.0.66).
•
Deny packets with destination IP addresses that belong to network 172.10.0.0/24 on XGE 5/0/0
of the RTC (90.16.0.66).
•
Limit the bandwidths to 50 Mbps for traffic with destination IP addresses that belong to networks
90.16.50.1/24, 90.16.50.1/24, or 90.16.50.1/24 on XGE 1/0/51 of the SWD (192.168.1.1).
•
Set the interface priority of XGE 1/0/50 to 5 and set the interface priority of XGE 1/0/51 to 3 on
SWD (192.168.1.1).
QoSM configuration analysis
This section lists the configuration tasks on QoSM.
•
Add classifiers that match the traffic.
•
Add behaviors of denying traffic and policing traffic.
•
Add QoS policies that contain classifier-behavior associations.
•
Import QoS policies to create QoS service.
•
Add deployment tasks to deploy QoS configurations to interfaces of devices.
Configuration procedures
Adding classifiers
To access the classifier list page:
1.
Click the Service tab.
2.
From the navigation tree, select QoS Manager > QoS Resource > Classifier.
Adding classifier to match the traffic from R&D department to file server
1.
Click Add on the toolbar.
The Add QoS Classifier page appears.
2.
Configure the following parameters: