Grass Valley LGK-3901 - Manual (Page 50)

GUIDE TO INSTALLATION AND OPERATION
44 | LGK-3901/DSK-3901
5 Installation
5.1 Unpacking LGK-3901
Make sure the following items have been shipped with your LGK-3901. If any of the following items are missing,
contact your distributor or Miranda Technologies Inc.
• LGK-3901 3G/HD/SD Logo Inserter & Downstream Keyer (2 cards connected)
• LGK-3901-3DRP-R Double Rear Panel
•
LGK-44-TBA Terminal Block Adaptor (if ordered)
The memory size of the fitted Compact Flash should correspond to the order.
5.2 Unpacking DSK-3901
Make sure the following items have been shipped with your DSK-3901. If any of the following items are missing,
contact your distributor or Miranda Technologies Inc.
• DSK-3901 3G/HD/SD Downstream Keyer (2 cards connected)
• DSK-3901-3DRP-R Double Rear Panel
• DSK-44-TBA Terminal Block Adaptor (if ordered)
The Compact Flash memory size should be 4GB.
5.3 Installation in the Densité frame
The LGK-3901/DSK-3901 and its associated rear connector
rear panel must be mounted in a Densité 3 RU frame. It is
not necessary to switch off the frame’s power when
installing or removing the card. See the Densité Frame
manual for detailed instructions for installing cards and their
associated rear panels.
The LGK-3901/DSK-3901 has multiple inputs and outputs,
and requires a double-width rear panel.
The LGK-3901/DSK-3901 comprises two physical cards
and must be installed into the two slots covered by the
panel in order to mate with the panel’s connectors.
If it is placed in the wrong slot, the front panel LED will flash
red. No damage will result to the device should this occur.
Figure 5.1 Installation of LGK-3901 and LGK-3901-3DRP-R in a Densité frame