Grass Valley K2 Dyno v.1.6 - Manual (Page 179)

15 April 2010 K2 Dyno Controller User Manual 179
Setting a destination
4. Touch and select the angle you want to send, and then touch SELECT .
• Choose Primary to send only the angle data that is set as primary.
• Choose ALL to send all of the protected angle data.
• Choose A , B , C , D , E , or F to send the angle data of the selected angle(s) among
them.
5. Touch the "Send setting" to set it to ON.
• If you want to set multiple destinations, repeat the steps 2 to 5.
6. Touch APPLY .
• When you touch APPLY , the settings are reflected.
• When you touch CANCEL , the settings are restored to the settings before
changes were made.