Running the setup wizard – Grass Valley SSP-3801 Installation v.1.2 User Manual
Page 29
25
SSP-3801
Installation and Configuration Guide
To log into an SSP-3801 card’s web interface:
1 Type the IP address of the SSP-3801 card into the address bar of a web browser. By
default cards are factory-configured and shipped with DHCP enabled. You can obtain
the card’s initial IP address using the Densité local control panel (see
Figure 4-1. SSP-3801 Login page
2 Specify a valid username and password and click OK.
If this is the first time you are logging into the SSP-3801, you should log in as follows:
• Username:
admin
• Password:
P1ayout
(the second character is the number 1)
The SSP-3801 web interface opens. All of the card’s parameters and settings are
available within the thematic menus on the left of the page.
Running the Setup wizard
The Setup Wizard makes configuring the SSP-3801 card easy and efficient. When you
launch the Setup Wizard, it will prompt you with a series of dialog boxes to provide the
information required.
The following are the types of information requested, followed by the menu command
where you can manually view or edit the information in the Card Configuration menu:
• Network Settings (System Identity, see
Configure the System Identity settings
• Integration service settings (System Identity, see
IMPORTANT
Later in the initial configuration procedure we recommend that you
disable the card’s DHCP setting and that you assign the card an
appropriate static IP address on your local network (see
IMPORTANT
If you are configuring the SSP-3801 card for the first time, we recommend
that you change password for the “admin” account. You cannot delete the
admin account. For more information, see