5 program run, Application, Program run – HEIDENHAIN TNC 128 (77184x-02) User Manual
Page 332: Test run and program run 13.5 program run
Advertising

Test run and program run
13.5 Program run
13
332
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
13.5
Program run
Application
In the
Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the
Program Run, Single Block mode of operation you must
start each block separately by pressing the machine
START button.
The following TNC functions are available in the program run
modes of operation:
Interrupt program run
Starting the program run from a certain block
Optional block skip
Editing the tool table TOOL.T
Checking and changing Q parameters
Superimposing handwheel positioning
Functions for graphic simulation
Additional status display
Advertising