HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 88)

Programming: Fundamentals, file management
3.2 Opening and entering programs
3
88
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
Possible feed rate input
Functions for setting the feed rate Soft key
Rapid traverse, non-modal.
Traverse feed rate automatically calculated in
TOOL CALL
Move at the programmed feed rate (unit of
measure is mm/min or 1/10 inch/min). With
rotary axes, the TNC interprets the feed rate
in degrees/min, regardless of whether the
program is written in mm or inches
Define the feed per revolution (units in mm/
rev or inch/rev). Caution: In inch-programs, FU
cannot be combined with M136
Define the tooth feed (units in mm/tooth or
inch/tooth). The number of teeth must be
defined in the tool table in the
CUT column.
Functions for conversational guidance Key
Ignore the dialog question
NO
ENT
End the dialog immediately
Abort the dialog and erase the block