HEIDENHAIN TNC 310 (286 140) - Manual (Page 182)

10 Programming: Q Parameters 170
1
0.7 A
dditional
F
unctions
Group name, ID No. Number Index System data
Pocket table data, 51 1 – Tool pocket location number
2 – Fixed pocket: 0=no, 1=yes
3 – Pocket locked: 0=no, 1= yes
4 – Tool is a special tool: 0=no, 1=yes
5 – PLC status
Pocket number for active tool, 52 1 – Pocket number in tool magazine
Compensation data, 200 1 – Programmed tool radius
2 – Programmed tool length
3 – Oversize for tool radius DR from TOOL CALL
4 – Oversize for tool length DL from TOOL CALL
Active transformations, 210 1 – Basic rotation in MANUAL OPERATION mode
2 – Programmed rotation with Cycle 10
3 – Active mirror axis
0: mirroring not active
+1: X axis mirrored
+2: Y axis mirrored
+4: Z axis mirrored
+8: IVth axis mirrored
Combinations = sum of individual axes
4 1 Active scaling factor in X axis
4 2 Active scaling factor in Y axis
4 3 Active scaling factor in Z axis
4 4 Active scaling factor in IVth axis
Active coordinate system, 211 1 – Input system
2 – M91 system (see section ”7.3 Miscellaneous
Functions for
Coordinate Data).”
3 – M92 system (see section ”7.3 Miscellaneous
Functions for
Coordinate Data).”
Datums, 220 1 1 to 4 Datum set manually in M91 system
Index 1 to 4: X-axis to IVth axis
2 1 to 4 Programmed datum
Index 1 to 4: X-axis to IVth axis
3 1 to 4 Active datum in M91 system
Index 1 to 4: X-axis to IVth axis
4 1 to 4 PLC datum shift