HEIDENHAIN TNC 320 (340 55x-05) - Manual (Page 27)

HEIDENHAIN TNC 320 27
11.1 Functions for Multiple Axis Machining ..... 340
11.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 341
Introduction ..... 341
Define the PLANE function ..... 343
Position display ..... 343
Reset the PLANE function ..... 344
Defining the machining plane with space angles: PLANE SPATIAL ..... 345
Defining the machining plane with projection angles: PROJECTED PLANE ..... 347
Defining the machining plane with Euler angles: EULER PLANE ..... 349
Defining the working plane with two vectors: VECTOR PLANE ..... 351
Defining the working plane via three points: PLANE POINTS ..... 353
Defining the machining plane with a single, incremental space angle: PLANE RELATIVE ..... 355
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 356
Specifying the positioning behavior of the PLANE function ..... 358
11.3 Miscellaneous Functions for Rotary Axes ..... 362
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 362
Shorter-path traverse of rotary axes: M126 ..... 363
Reducing display of a rotary axis to a value less than 360°: M94 ..... 364
Selecting tilting axes: M138 ..... 365
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 366
11 Programming: Multiple Axis Machining ..... 339