HEIDENHAIN TNC 320 (340 55x-05) - Manual (Page 475)

HEIDENHAIN TNC 320 475
Miscellaneous functions
M Effect Effective at block... Start End Page
M0 Program run STOP/Spindle STOP/Coolant OFF „ Page 305
M1 Optional program STOP/Spindle STOP/Coolant OFF „ Page 434
M2 Program run STOP/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 „ Page 305
M3
M4
M5 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP „
„
„
Page 305
M6 Tool change/Stop program run (depending on machine parameter)/Spindle STOP „ Page 305
M8
M9 Coolant ON
Coolant OFF „
„
Page 305
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON „
„ Page 305
M30 Same function as M2 „ Page 305
M89 Vacant miscellaneous function or
Cycle call, modally effective (depending on machine parameter) „
„
Cycles
Manual
M91 Within the positioning block: Coordinates are referenced to machine datum „ Page 306
M92 Within the positioning block: Coordinates are referenced to position defined by
machine tool builder, such as tool change position „ Page 306
M94 Reduce the rotary axis display to a value below 360° „ Page 364
M97 Machine small contour steps „ Page 309
M98 Machine open contours completely „ Page 311
M99 Blockwise cycle call „ Cycles
Manual