Manual operation and setup – HEIDENHAIN TNC 320 (340 55x-05) User Manual
Page 28
28
12.1 Switch-On, Switch-Off ..... 368
12.2 Moving the Machine Axes ..... 371
Moving the axis using the machine axis direction buttons ..... 371
Incremental jog positioning ..... 372
Traversing with the HR 410 electronic handwheel ..... 373
12.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 374
Changing the spindle speed and feed rate ..... 375
12.4 Datum Setting without a 3-D Touch Probe ..... 376
Workpiece presetting with axis keys ..... 377
Datum management with the preset table ..... 378
12.5 Using the 3-D Touch Probe ..... 384
Selecting probe cycles ..... 384
Writing the measured values from touch probe cycles in datum tables ..... 385
Writing the measured values from touch probe cycles in the preset table ..... 385
12.6 Calibrating the 3-D Touch Probe ..... 386
Calibrating the effective length ..... 387
Calibrating the effective radius and compensating center misalignment ..... 388
Show calibration values ..... 389
12.7 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 390
Measuring the basic rotation ..... 391
Saving the basic rotation in the preset table ..... 391
Displaying a basic rotation ..... 391