HEIDENHAIN PROFINET - Manual (Page 92)

Firmware upgrade
92
8.1 Firmware upgrade in a PROFINET network
The following prerequisites have to be fulfilled in order to upgrade
the encoder in a PROFINET network:
• The encoder should be attached to the network.
• The encoder must have a valid Device name and a valid IP ad-
dress (assigned with DCP).
• A TFTP server should be enabled on the LAN where the en-
coder is attached. See chapter 8.4 for an example how to set
up a TFTP server.
Once the encoder has been assign a valid IP address it should be
accessible on the network. Enter the encoders IP address in the
WEB browser to open the Firmware upgrade page.
Figure 39 Firmware upgrade startpage