SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 20)

6 Electrical Connection SMA Solar Technology AG
20 BTREPOUT-IA-en-11 Installation Manual
1. Loosen the screws of the enclosure lid and remove the lid.
2. Unscrew the nut from the lower left corner of the cable gland and push out the filler-plug.
3. Preparing the cable:
– Remove 40 mm of the cable sheath from the
side of the Bluetooth Repeater Outdoor.
– Shorten unused insulated wires flush with the
cable sheath.
– Strip approx. 10 mm off the wires.
4. Insert the cable into the enclosure through the nut
and the cable gland.
5. Connecting the cable to the feed-through terminal
in the enclosure:
– Push the terminal 1 and terminal 2 of the
feed-through terminal open using a screwdriver
(2.5 mm).
– Connect the conductor to terminal 1 and the
insulator to terminal 2.
6. Separate the AC grid connection point from the alternating current grid using the separator.
Thus you ensure that there is no voltage present at the AC grid connection point.
7. Connect the Bluetooth Repeater Outdoor to the voltage supply.
• Plug the grid connection plug into the socket-outlet, if a grid connection plug is used.
• If no grid connection plug is used, connect the other end of the cable to the voltage supply
as desired, e.g. via a cable junction box.
8. Connect the AC grid connection point to the AC grid using the separator.
☑ LED DC OK of the top-hat rail power supply unit and LED RDY of the Bluetooth Repeater
Outdoor are glowing green
✖ LED DC LO of the top-hat rail power supply unit or LED RDY are not in operation or are
glowing yellow?
• Rectify the fault (see Section 10.1 "Voltage Supply", page 27).