SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 24)

7 Settings SMA Solar Technology AG
24 BTREPOUT-IA-en-11 Installation Manual
1. If you do not know the plant NetID, read off the NetID from one of the devices in the plant
(see the manual of the device).
2. Remove the seal insert of the screw seal from the top
of the enclosure of the Bluetooth Repeater Outdoor
with a screwdriver (2.5 mm). Thus you can see the
NetID rotary switch and the Bluetooth LEDs in the
inside of the enclosure.
3. Use a screwdriver (2.5 mm) to turn the arrow of the NetID rotary switch to the plant NetID.
4. Insert the seal insert of the screw seal and tighten it using a screwdriver (2.5 mm). This ensures
the degree of protection IP54.
NetID 1 is possible for plants with 1 inverter
You may leave the default NetID set to 1 in your inverter if your Bluetooth plant consists of the
following products:
• A maximum of one inverter
• A maximum of one computer with Bluetooth and the Sunny Explorer software
• A maximum of one Sunny Beam of type BEAM-BT-11.GR1
or
• A maximum of one inverter
• A maximum of 2 Sunny Beams of type BEAM-BT-11.GR1
In all other cases you must determine a free NetID (see Sunny Explorer Help).