SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 31)

SMA Solar Technology AG 10 Troubleshooting
Installation Manual BTREPOUT-IA-en-11 31
The Bluetooth Repeater
Outdoor is not connected to
the Bluetooth network: • Check the NetID.
• Change the position of the
Bluetooth Repeater Outdoor
or install additional
Bluetooth Repeater Outdoor
devices.
off Three LEDs off
There is no device with the
same NetID within the radio
range.
The SMA Bluetooth network
has not been established.
Only masters, e.g.
communication products,
initiate network
establishment.
• Commission a master in the
SMA Bluetooth network.
The NetID rotary switch is
set to position 1 or 0. • Set the NetID rotary switch
to the NetID of your plant
(see Section 7.2).
Three LEDs are
flashing
The Bluetooth Repeater
Outdoor firmware is
defective. • Contact the SMA Service
Line.
is flashing
and RDY
LED is
flashing
green Three LEDs are
flashing
Bluetooth LEDs
Status
Meaning Measure
blue LED yellow LEDs